Antenna Wall Mount 18 inch Standoff Y Style Deluxe Brackets for 1.00 to 1.75" OD Mast
3 Star Inc
Made in the USA!
The 3S-WM18 Antenna Mast Wall Mount Set of (2) Double "Y" Style Brackets, One with a Vertical Brace Strut on the Bottom Bracket, with Hardware Included for an 18 inch Standoff Wall Support of Light to Medium Duty Antennas on Mast Poles from 5 to 10 feet long and from 1.00 to 1.75 inches in Outside Diameter for Off-air and OTA TV, UHF/VHF Radio, Remote Telemetry Control and Monitoring Stations, Cellular Date Gateways, WiFi, Wireless Internet, Receivers, Boosters and Repeaters.(Mast Not Included)
These mast mountings are typical and generally require the cantilever distance between the mounts be one quarter (1/4) to one third (1/3) of the mast length depending on Wind Load, starting from the bottom with 2 foot between brackets being a minimum distance. All Masts greater than ten feet in length, and/or 2 inches or greater in O.D. should be based upon and from the ground in rising up to the desired height.
Also for Telescopic Mast Poles comprised of 1.25", 1.50", 1.75", 2.00" and 2.25" Tubes nested together and then extended, these wall mounts can supplement structural support but are not designed to take the place of a Base in Supporting the weight of the Mast off the ground or guying. Be sure and check that the Tube segments you wish to wall mount will fit within the Outside Diameter Window specified that the Brackets will accommodate. Set screw installation may require some field drilling.
Manufacturers recommend that ALL masts above 10 feet from their uppermost support be Guyed
With more height in your installation, Grounding/Bonding is a recommended consideration.
Download
An adapter (or adaptor) is a device used to match the physical or electrical characteristics of two different Connectors so that a connection may be made between them and the Equipment You desire to Cross-Connect. Most Connections for Video and RF (Radio Frequency) Equipment is 75 Ohm in Characteristic Impedance. Radio and Microwave Frequency Connections Passing High Power Require 50 Ohms. A Majority of the Adapters offered Here are 75 Ohm. However, with the High Quality Dialectric Found Surrounding the Interior of the Mating Connection, Low Power Usage, and Transition Impedance Matching of Like Characteristic Impedances, Resulting Mis-match of 50 Ohm use woiuld be so Low as to be Considered Negligible.
