2-7/8" to 3-1/2 inch OD Pipe to Pipe, Pole or Tower 90° Crossover Plate Kit 3S-2530
3 Star Inc
This 3S-2530 Heavy Duty Pipe to Pipe, Pole or Tower Perpendicular Crossover Plate Kit mounts a 2-7/8" inch OD Pipe or Antenna Mast Pole at 90 degrees to a 3-1/2" inch OD Pipe, Tube or Round Tower member component via Hot Dip Galvanized (HDG) U-Bolts, and clamping them together to a 3/8" inch thick, 7.00 x 8.75 inch HDG 3S-SCX4 Crossover Plate. This is typically used for the mounting of Conduit on a Tower, Building or Roof, as well as Antenna(s) (TV, Wireless Internet, Cellular Gateway, MIMO, DBS, Satellite, Microwave, Panel, Dish and Array) usually attached to other masts and pipe, Tower legs, Railings, Balconies, Roof Tops, etc.
Includes U-bolts, Plate and associated Hardware, Pipe and Mast Tubes are Not included but are available separately
Refer to "Specification" Tab above for More Detailed Information.
DownloadWe carry a huge selection of Crossover mounts designed to support most WiFi, PCS, Cellular, and TV antennas, allowing you to vary the mounting pipe length and diameter. All of our mounts are weather protected using either a HDG (Hot Dipped Galvanized) or a Pre-Galvanization finishing process for corrosion protection. You can increase the amount of strength and holding power by utilizing multiple mounts space out over the length of the mounting pipe. There are many reasons you might need to use these mounts and they mostly involve the need to attach a pole to another pole to either extend the original or simply as an attachment point.
