1" to 2 inch Pole to Pole or Pipe Antenna Mast 90° Crossover Clamp Bracket Kit C-MT
3 Star Inc
Made in the USA!
This C-MT is a Medium Duty 1" to 2 inch Antenna Mast Pole to Pole, Pipe or 25G/45G/55G ROHN Tower Leg Rail Cross-Over Clamp Bracket Kit that mounts a 1" to 2 inch OD Pipe or Antenna Mast Tube perpendicularly at 90 degrees to another 1" to 2 inch OD Pipe, Tube or Round Tower member component via Galvanized U-Bolts, by clamping them together via a 1/8" inch thick, 4.75 x 7.25 inch Galvanized Steel Crossover Plate. This is typically used for the mounting of TV, Wireless Internet, Cellular Gateway, MIMO, UHF, VHF, Weather Station or Telemetry Antenna Mast Poles and Pipe usually attached to other masts and pipe, Tower legs, Railings, Balconies, Roof Tops, etc. Sometimes used to affix a Twin antenna U-Mast Assembly to a vertical mast, but mostly used to affix a vertical mast to and existing horizontal appurtenance. Each Kit includes one (1) plate and four (4) U-Bolt Assemblies.
Pipe and Mast Tubes are Not included but are available separately
Refer to "Specification" Tab above for More Detailed Information.
Features and Specification
- Vertical or Horizontal Mounting
- Pre-Galvanized Mounting Plate
- Plate Dimensions 5" x 7"
- U-Bolts Round Bend:
(2) 5/16" x 2.00" Wide x 4-3/16" Long
(2) 1/4" x 2.00" Wide x 3.00" Long - Kept Nuts: (4) 1/4" and (4) 5/16"
Maximum Tubing Size: 2.00" Outside Diameter
DownloadPipe to Pipe or Mast Pole to Tower Leg Crossover Clamp Sets and 90° Perpendicular Mounts
Crossover Mounts accommodating 2-3/8" OD through 4-1/2" OD Mast Tube Pipe are HDG (Hot Dipped Galvanized).
Crossover Mounts accommodating 1.00" OD through 2.25" OD Mast Tube are of a Pre-Galvanized Plated Finish.
All are used to Fixate and Hold (2) poles to cross perpendicularly, one to the other, preferably from an integral Structure Member to another, or even Freestanding. An Example would be attaching a Vertical Mast Pole Tube to an existing Horizontal Welded Guard Rail at two levels (Top and Mid rail) utilizing (2) Crossovers as to maintain a Cantilever against Weight and Wind Loading on the Mast being installed.
If You need to attach a Vertically Running Mast Pole to the Vertical Post, please refer to the "Pole to Pole Mount" Category in this section!
You can increase the amount of strength and holding power by utilizing multiple mounts space out over the length of the Mounting Pipe. There are many reasons you might need to use these mounts and they mostly involve the need to attach a pole to another pole to either extend the original or simply as an attachment point for prime placement location.
Both Pole to Pole and Crossover Mounts are designed to support most WiFi , PCS, Cellular, SCADA, TV and Other Light to Midweight antennas. Consult a Structural Engineer if meeting Wind Speed survivability ratings is necessary.
All of Our Mounts in this Category can easily be shipped UPS, depending on QTY Dimensional Weight.
