5' Foot Antenna Mast Pole Swaged End 1.25" inch OD 16 AWG Galvanized Pipe | EZ 5-16 S
3 Star Inc
Made in the USA!
This 5 Foot (60") by 1.25" OD 16 AWG swaged end Antenna Mast tube is galvanized for weather and used to extend any 1-1/4 inch 16 gauge antenna masts by fitting the swaged end of this mast into the open end of the another mast tube of the same diameter and gauge, thereby extending the existing mast an additional 5 feet. Fits a Variety of Mounts for Flexibility In Antenna Mounting and Height Clearance. There's a Big difference between 18 AWG and 16 AWG when it comes to joining Swaged to Straight Antenna Masts. You cannot mix and match 16 and 18 gauge masts so please, verify the mast you have before purchasing a complimenting swaged section. Be Sure and afford yourself 2 feet minimum, up to 1/3 of the overall mast length between the two wall mounts you would utilize in your TV antenna Installation. The Torque applied from wind load through cantilever to these mounts can be significant.
Manufacturers recommend that mast heights of 10 feet and higher be guyed.
(Mount Not Included)
There's a Big difference between 18 AWG and 16 AWG when it comes to Antenna Masts. This 16 AWG Mast is thicker, hardier, stronger and weighs more with heavier Pre-Galvanization. The swaged end fits tightly into another mast when it's 16 AWG like this one (I can't pull them apart, bolt them together for a permanent joint). When considering the longevity of your HDTV Off-Air TV Antenna, there's no substitute for the strength of this mast in effectively transfering the Wind Load from the Antenna to the Mount in preventing the mast from Folding over. The 18 AWG painted masts just don't hold up. Be Sure and afford yourself 2 feet minimum, up to 1/3 of the overall mast length between the two wall mounts you would utilize in your TV antenna Installation. The Torque applied from wind load through cantilever to these mounts can be significant. This is one reason we no longer offer the 18 AWG masts such as the Channel Master CM-1805 or Cm-1810.
The ROHN SSV HD tower has the same features and utility as the SSV tower, but with Heavy Duty legs and braces. The heavy duty tower allows for the structure to support more loading and higher wind and ice loading. This tower serves the same applications as the SSV including: PCS, broadband, security, sports lighting and many others. The SSV HD also has standard “pre-engineered” towers created from standard sections. All ROHN SSV towers are hot-dip galvanized, inside and out for corrosion protection.
| General Notes: 1. Standard tower designs are in accordance with approved national standard ANSI/TIA-222-G, Structure Class II, Topographic Category 1, 3/4” design ice thickness, seismic coeffilient SS < 1.0. 2. Tower designs assume allowable projected areas are symmetrically placed on the tower. 3. Designs assume one 7/8 line to top and two 7/8 lines to 30 feet below top, one line on each face. 4. All towers are provided with step bolts and a tapered top. 5. Grounding kit must be ordered seperately. 6. Assembly drawings and standard foundation details are supplied with the tower. 7. Custom designs for site-specific applications are available upon request |
 |
 |
 |
