Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
ProductQtyPrice
125 FT RG11...1$59.00
Goods Total1$59.00
View Cart Check out

Categories

Printer View Tell a Friend

ROHN FRM238 Non-Penetrating Roof Antenna Mount 2.375" OD x 30 inch Mast

Price$148.00
Manufacturer CodeFRM238
Qty
AvailabilityShips in 1 to 3 Days

Highlights

No penetration on roof surface
Galvanized for corrosion protection
Designed for concrete block ballast
Mount Goes together quickly
Minimum of bolted connections
Optional roof pads/mats available

Bulk Quantities Available Here!

ROHN FRM238 Non-Penetrating Roof Antenna Mount 2.375" OD x 30 inch Mast
Made in the USA!Made in the USA!
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 3’ square with a 16" tray to fit concrete blocks, typically used as ballast for placement of various TV, Radio, Microwave, WiFi and Wireless Internet Antennas. The base mount is 16 gauge Pre-Galvanized and the mast tube is thick-walled galvanized steel for corrosion protection and go together quickly.
Mast Dimensions - 2.375" 14 GA Pipe (2-3/8 O.D.) x 30”
Antenna and wind loads vs ballast weight, Spec.s and Buyers Guides are found in the Specification Tab above.


Height and Antenna Loading capability are dependent upon ballast weight. You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. Please refer to the Chart (pdf link above) which is a great place to start in determining whether your circumstances qualify for such an installation. If you cannot find someone local to evaluate the registered plans for your Flat Roof Structure, ROHN may be able to put you in contact with someone who can.

Specification Sheet
ROHN FRM Spec. Sheet
Buyers Guide
ROHN FRM Buyers Guide
ROHN Roof Mounts Buyers Guide
Foundation
ROHN Ballast Requirements
Antenna EPA & Loading
ROHN EPA Wind Formula

RG-59 Direct Burial Cable for Underground Installations

The days of running cable on top of the Ground and dodging it with the Lawn Mower are gone. If you intend to invest in Cable Plant that will be placed from Building to Building, or from one Cable TV, Satellite TV, Antenna TV or Security Camera location to another, we encourage you to use the Products we Offer that were designed Specifically for this purpose. Within this Category, you will find Coaxial Cable specifically Designed for Direct Burial and Conduit Placement in the Ground, for dedicated runs or mass distribution. Our Customers typically use these Products in the following Scenarios:

Mobile Home Parks- Where they are Administrating their own Cable TV or SMATV System with Underground Outside Plant running along the same easement that Telephone and Power runs past each Lot. UG Installation is a little more expensive to install, but is more aesthetically pleasing. In the same Conduits and Trench-lines, Modulated Security Camera feeds run through this cable, each independently from a camera to a Central Location for further processing and recording. Once processed and combined as TV channels along with the others offered, they distribute these Camera Feeds for residents to monitor their guests and service appointments arrivals and departures, sharing the Security Responsibility with all.

Small Apartment, Condominium, Hotel and Motel Complexes not only use this cable for Strategically placed Security Camera Feeds from Entry point locations, but as a means of MATV Antenna Installation, distributing their own Signal to meat up at the same Lock-boxes that serve as central location connections to the units inside. Where the managers of the Property may have provided Cable TV or Satellite (SMATV) systems on the Properties, some Tenants may not be able to afford it, having an alternate feed those residents opting for Free Off-Air TV beats having several located on the Balconies. Antenna Reception may not be equal at any location on the Property, and only one or several locations my be deemed sufficient in Signal Quality or Aesthetics concerns. Building to Building Coaxial Cable Feeds run underground may be the answer as it will serve to maintain the Codes and Policies in place without necessity of deviation or waiver.

The same Antenna location issues are faced by Home Property owners Large and Small. There may be only one location not blocked by Trees or other buildings to locate the Antenna, and of course, the signal is needed some place else. Again, Underground Placement of Coaxial Cable in Conduit is a path that can be revisited and up-graded by simply pulling out the Old and pulling in the New.

We are here because we don't just Sell these Products, we use them also. We have decades of experience around the World in System Construction and Maintenances. So don't be shy, call us with your particular need, and let's see what we can come up with for a Solution (besides, Free Advice!)