Towers | Poles | Mounts | Masts | Hardware | Guy | Cable | Wire | Carts | Racks | Tools
Your Cart
ProductQtyPrice
1.25" inch...1$14.95
Goods Total1$14.95
View Cart Check out
Printer View Tell a Friend

ROHN H30 30' foot Telescopic Mast Outdoor Antenna Pole

Price$126.00
Manufacturer CodeH30
Qty
AvailabilityUsually ships in 24 Hrs

Highlights

Use As Guyed
or Bracketed
Guy Rings Rotate
Five Guy Holes/ Ring
Masts have hardware
27 ft extended Height

Bulk Quantities Available Here!

ROHN H30 30' foot Telescoping Mast Outdoor Antenna Pole
Made in the USA!Made in the USA!
Used for Off-Air TV Antenna, Amateur (Ham) Radio, Wireless Internet Antenna, MMDS and Cell Phone Signal Booster, Emergency Dispatch and Public Utilities Installations. All aerial Telescoping push-up Masts are galvanized and come with hardware designed to support light duty aerial antennas. The unique ROHN design features interior tube flanging combined with a double crimped exterior tube to produce a stronger and more stable joint than most common mast. Each section extends deeper into the lower tubes than most designs, adding to the masts stability. Height listed describes the overall pipe length. Due to overlapping sections of pipe, the extended masts will be shorter. This Mast fully extends to about 27' Feet. The shipping dimensions are 10' feet x 4" x 4" and ships Freight Only to Commercial and Residential addresses.
Manufacturers recommend that masts heights of 10 feet and higher above the uppermost bracket be guyed for Addition Wind Load Support. Bonding/Grounding should be made by affixment to Mast. Consult NEC and Applicable Local Code for further guidance
(Antenna, Down Guys and Mounts not included).

35 ft extended Height

Mast Section Dimensions are:
(1) 10'0" length x 1.25" O.D. (16 AWG)
(2) 9'10" length x 1.50" O.D. (18 AWG)
(3) 9'04" length x 1.75" O.D. (18 AWG)

This Item Ships LTL Freight ONLY.


Note

Installation Guidelines:

  1. Installation or dismantling of telescoping masts require professional contractors experienced with guyed masts.
  2. All installations must be bracketed or guyed.
  3. The pictured guy wire kit layouts are for a typical installation. Individual installation requirements may vary.
  4. Antenna load (top load) should not exceed an effective projected area (EPA) of 2 square feet (see your antenna specifications).
Installation Sheet
Telescopic Mast Install
Buyers Guide
ROHN Telescopic Mast