ROHN
Made in the USA!
The WM212NP Antenna Wall Mount provides 12 inch Standoff clearance from the wall and is hot-dip galvanized for corrosion protection. Complete Set includes (2) 12 inch Wall Mount Brackets for Off-air and OTA TV, UHF/VHF Radio, Remote Telemetry Control and Monitoring Stations, Cellular Date Gateways, WiFi, Wireless Internet, Receivers, Boosters, Repeaters and Small Microwave Dishes.(Mounting Hardware and Mast Pipe Not Included)
An Optional WMB12A Diagonal Support Strap Kit provides additional Vertical Structural Integrity. The WM212 Brackets are pre-drilled to accept the 1/2” Diagonal Strap Hardware.(Option Not Included)
Specifications
Wall Clearance: 12.000 in.
Mounting Holes : 24" Center to Center
Mast Clamp Size Range: 1.5" to 2.75 in.
Mast Included: NO
Hardware Included: Yes
Diagonal Strap Kit: Optional
Mounting Pipe: Optional
Antenna Mast Wall Mount Brackets for Off-air and OTA TV, UHF/VHF Radio, Remote Telemetry Control and Monitoring Stations, Cellular Date Gateways, WiFi, Wireless Internet, Receivers, Boosters and Repeaters.
From Sets of Heavy Duty "W" Style Brackets with Hardware Included to "Y" Styles Brackets for Standoffs from the Wall of 2 to 24 inches Supporting Light to Medium Duty Antennas on Mast Poles from 5 to 10 feet long and from 1.00 to 3.00 inches in Outside Diameter.
These mast mountings are typical and generally require the cantilever distance between the mounts be one quarter (1/4) to one third (1/3) of the mast length depending on Wind Load, starting from the bottom with 2 foot between brackets being a minimum distance. All Masts greater than ten feet in length, and/or 2 inches or greater in O.D. should be based upon and from the ground in rising up to the desired height.
Also for Telescopic Mast Poles comprised of 1.25", 1.50", 1.75", 2.00" and 2.25" Tubes nested together and then extended, these wall mounts can supplement structural support but are not designed to take the place of a Base in Supporting the weight of the Mast off the ground or guying. Be sure and check that the Tube segments you wish to wall mount will fit within the Outside Diameter Window specified that the Brackets will accommodate. Set screw installation may require some field drilling.
Manufacturers recommend that ALL masts above 10 feet from their uppermost support be Guyed.
With more height in your installation, Grounding/Bonding is a recommended consideration.