Rohn 1/2TBE&J Turnbuckle 1/2 x 12 inch Round Eye to Jaw

ROHN 1/2TBE&J 1/2" x 12" ROUND Eye to Jaw Turnbuckle
Round Eye Turnbuckle, Forged, Hot Dip Galvanized, Open Body, Eye to Jaw, Working Load Limit: 2200 lbs., Ultimate Strength: 11000 lbs.

FEATURES

Turnbuckle are used as adjustable extension links to maintain proper tower clearance on assemblies at tower end. The body of the turnbuckle is reverse thread on opposite ends to allow tightening/loosening by simply turning the body of the turn buckle. Made of  galvanized steel, our turn buckles are built to last and weather resistant .

Specs

Item#                      : 1/2" TBE&J 

Product Name          : Turnbuckle, Eye and Jaw, Galvanized, 1/2" x 12"

Type                       :  Eye and Eye

Diameter                  :  1/2"

Take-up                   :  12"

Closed Length          :  16"

Working Load Limit  : 2,200 lb -Working load limits are based on a safety factor of 5 to 1

Material                    : Forged Steel

Finish                       : Hot Dip Galvanized

Specification             : Federal Spec FF-T-791B Type 1 Form 1

 

 

Spec. Sheet

 

---

Typical Use: when attaching and tensioning ROHN Tower and Telescopic Antenna Mast Down Guy terminations (3/16" Strand via Pre-formed dead-end and 5/16THH, 1/4" Bare Strand via Cable Clamps and 5/16THH, 1/4" Strand via Pre-formed dead-end and 3/8THH to Equalizer Plate Anchors (Sandwich Plated like GAC305/EP25345 or GAC303/EP25343). Eye to Eye Turnbuckles typically attach the Tower Down Guy Strand (via a Big Grip Pre-formed Dead-End and a Heavy Open Thimble) on one end to the Down Guy Equalizing Plate (the ones that use Bolts as the attachment Method, ie; R-GAC303, R-GAC305, EP25343 and EP25345) attached to the Anchor on the other end. Consult ROHN Catalog Links at Footer Section below for ROHN 25G 45G 55G 65G Tower Guy wire Details for Various Wind Loads.
Compare to ROHN R-3/8TBE&E 3/8 inch Eye to eye Turnbuckle and Channel Master Turnbuckle Part# 1369!