EZ NP-175 Non-Pen Roof Mount FRM Frame for up to 1.75 inch OD Antenna Mast
3 Star Inc.
Made in the USA!
Ideal for Light Off-Air TV and Wireless Internet Antenna mounting This small Non-Penetrating Flat Roof Mount is constructed of pre-galvanized steel, uses 6 standard concrete blocks to anchor, 28.5 x 35.5" base, accepts masts from 1.00 to 1.75 inch O.D.
For light antenna loads needing 10 feet in height, use this mount in combination with (2)EZ 5-16S swaged 1.25" O.D. masts, several EZ 50 turnbuckles, some 620 guy wire and the EZ 43-A Guy Ring! (available separately)
Also can be used as a non-pen base for an H20 or H30 Telescopic mast, though down guys will still be required as per Factory recommendations.
Download
Pitched and Roof Peak Non-Pen Mounts
This Non-Penetrating Pitched Roof Mounts is constructed of Pre-Galvanized Steel and uses standard concrete blocks. Accommodates a wider range off Foot-plates for use to mount AU9S Dish, DirecTV 5 LNB Dish AU9 Slimline, WildBlue, SuperDISH, DirecTV Ka/Ku (HD Dishes), Satellite Dishes compatible with the SuperDMount, DirecTV AT9, DBS Direct Broadcast Satellite and FTA Free to Air using a 2.00 inch OD Outside Diameter Mounting Pipe. In addition, it can be used in mounting some smaller Microwave PCS, Cellular, Broadband Wireless, Wireless Internet and Two Way Antennas compatible with 2 inch OD Pipe Mounting. I have enjoyed Installing this product line for Dish applications from Business and Internet on the tops of tall buildings to HD TV and zillions of channels for in-home use. And as with all items in this Product Line, Screws and Pitch Pads are included for Bolt-down versus Ballast applications. The Length of the mast is 30 inches based on engineering that incorporates consideration for typical Satellite Antenna Wind-load versus the Ballast that would keep either on target with minimal deviation and flex. As with all Ballast mounts, Structural Engineering consultations are recommended for all Roof Applications.
Sorry, we are offline,
click here to send us message
