2 Foot Roof Mount Tripod with Antenna Mast
3 Star Inc
Tripod holds mast up to 2-00 inch OD and is made of 1.25"OD-18 Gauge Galvanized tubing has a universal mast clamp and has installer friendly front facing feet that line up 16 inches center to outer legs , a 28" x 1.66" Pipe Included. Can be Customized for Off-Air Antenna or DirecTV and Wild Blue Satellite Dish.
A 28" x 1.66" OD Pipe is OPTIONAL with the appropriate Mast Pipe. (Pitch Pad Kit, Mounting Hardware Not Included)
Typical rafter spacings are 16 inches center to center and pre-built trusses are 24 inches center to center. Heavy Duty 18 Gauge Galvanized Steel 3 ft. Antenna Tripod can Permanently mount an antenna or satellite dish on the peak of a roof, or almost anywhere!
ROHN 65G Series Tower Sections & Concrete Embed Bases
Since there are various other Manufacturers of Towers and Tower accessories that copy the ROHN Tower design, if you are not sure of the manufacturer of your Tower, you can at least compare the actual measurements and design of yours to those found in the spec. sheets in the ROHN catalog section via the Link provided above to assure yourself that additional sections or parts will fit. We cannot make that determination for you as the ROHN clones are something we don't carry or otherwise represent in our Product line.
All Tower sections in the 65G Series use bolted flange joints in connection with other sections. Featuring a 24-1/4 inch equilateral triangular design, the 65G is constructed of extra heavy duty 1.90" O.D. steel tubing side rails measuring 24 inches Center to Center with continuous 5/8" solid steel rod bracing and are constructed with high strength steel tubing and feature ROHN's exclusive Zig-Zag ® solid rod bracing to provide exceptional strength. All 65G Series Towers are hot dip galvanized after fabrication. In this process, each section of the tower is totally immersed in molten zinc, allowing every square inch of the tower, inside and out, to be completely covered. Hot dip galvanizing protects all points of welding and construction against rust and corrosion while providing an attractive finish.
The 65G is a true multi-use structure that provides excellent strength for applications up to 500´ with heavy steel tube legs to satisfy a wide variety of needs under varied conditions. When properly installed, the standard tower will support the loads shown on various guyed and self-supporting information sheets in the ROHN catalog.
Most Restrictions Allow for 40 feet of Height without the Necessity of Guy Wires, Anchors or Braces. However, No Tower is self supporting during construction! Always use temporary guys on the top most section, and install permanent guy wires as soon as a guy point height is reached.
This Buyers Guide will answer many questions you may have on this Product Line.
