Safety Cable Tether Kit for ROHN Non-Penetrating Roof Mounts
ROHN
This Safety Cable System is used to Securely Tether Ballast dependent Roof Mount Appurtenances to stay in Position on the Roof in the Event of Movement due to Excessive Wind, Seismic Events, etc. It will Necessitate a Structural attachment to a Integral Member of the Roof that can bear the load. Recommended that you Engage a Structural Engineer before Drilling as Structural Anchor Point Hardware is Not included.
Kit Includes:
(1) 150' Coil 3/16" EHS Guy Cable
(6) 3/16" HDG Cable Clamps
Size & Grade Tensile Strength lbs
Initial Tension lbs
3/16" H.S. 2850 300
3/16" E.H.S 3990 400
1/4" H.S. 4750 500
1/4" E.H.S. 6650 700
5/16" H.S. 5350 550
5/16" E.H.S. 11200 700
3/8" H.S. 10800 1000
3/8" E.H.S. 15400 1500
Antenna Guy Wire for Guyed Towers & Telescopic Masts
3 Star Stocks EHS 7 Strand Guy Wire for use on ROHN 25G, 45G, 55G and 65G Guyed Towers Systems as well as Utility OSP Cabled and Fiber Systems. Our EHS Tower Guy wire comes in 100', 250', 500',1000, in coils or reels and 5000 FT wooden spools. PLP-GWD Guy wire Dispenser available (optional). It is recommended that "Initial Tension" (10% of Maximum Limit) is attained with the Turnbuckle travel extended prior to tensioning with same. Annex the Data shown in the Table below when referencing guy charts shown for ROHN Towers:
Our 6/18 (6 strand 18AWG) and 6/20 (6 strand 20AWG with or with out Plastic Coating) guy wire comes in lengths of 50', 100', 250', 500' up to 1000' FT. Choose from 6/18 and 6/20 for Guying Telescopic Antenna Masts. Also, Complete Telescopic Guy Wire Kits are also available.
Sorry, we are offline,
click here to send us message
